120 volt led power supply dimmable 12vdc for led lights
120 volt led power supply dimmable 12vdc for led lights is IP20 design for indoor installation, dimming function: Built in DALI interface dimming function conform to DALI Protocol IEC62386 and the dimming range from 0.1% to 100%,Can be used with LUTRON TG-600PR-IV dimmer,Achieve smooth dimming effect.
Specification
Model
SMT-012-036VM
SMT-024-036VM
SMT-036-036VM
SMT-048-036VM
output
DC Voltage
12V
24V
36V
48V
Voltage Tolerance
±0.5V
Rated current
0~3.0A
0~1.5A
0~1.0A
0-0.75A
Rated power
36W
input
Voltage Range
100~130VAC, 170~265VAC
Frequency Range
47~63HZ
Power Factor (Typ.)
PF≧0.90/110V / PF≧0.90/220V
Efficiency(Typ.)
>88%
>88%
>88%
>88%
AC Current(Typ.)
0.41A@110VAC
0.21A@VAC
Leakage current
﹤0.40mA/110VAC / ﹤0.50mA/220VAC
Protection
Short Circuit
Hiccup mode, recovers automatically after fault condition is removed
Over Loading
≦120%
Environment
Working TEMP.
-40~+60℃
Working Humidity
20~90%RH, non-condensing
Storage TEM.,Humidity
-40~+80℃,10~95%RH
TEMP.coefficient
±0.03%/℃(0~50℃)
Vibration
10~500Hz,2G 10min./1 cycle,period for 60min. each along X,Y,Z axes
Safety&EMC
Safety standards
EN61347-1 EN61347-2-13
Withstand voltage
I/P-O/P:3.75KVAC
Isolation resistance
I/P-O/P:100MΩ/500VDC/25℃/70%RH
EMC EMISSION
EN55015,EN61000-3-2,3 (≧50%loading)
EMC IMMUNITY
EN61000-4-2,3,4,5,6,11(Surge 4KV)
Others
Net.Weight
0.55Kg
Size
180*60*34mm(L*W*H)
packing
355*215*215mm/20pcs/CTN
Notes
1. All parameters NOT specially mentioned are measured at 110V / 220VAC input , rated load
and 25℃of ambient temperature.
2. Tolerance: includes set us tolerance, line regulation and load regulation .
3. The power supply is considered as a component that will be operated in combination with final Equipment. Since EMC performance will be affected by the complete installation, the final equipment manufactures must be-qualify EMC Directive on the complete installation again
Label
Mechanical Specification
※Input with Live Wire(L) Neutral Wire (N)
※Output LED SEC output Positive(LED+),output negative(LED-).Connected to LED Lamps.
※Signal Dimming (DA1), (DA2) DALI Non polar!Connected to the BUS of the DALI Master.
※ When installing the LED driver and making input and output connections, cross-section area of conductor for input and output terminal block:0.75mm²(cord type: H03VVH2-F or H03VV-F).
※Please make sure you connect these correctly otherwise your product will not function correctly and could be damaged.
Opreation reference
■Instruction:
1)This driver should be installed by qualified and professional person;
2)Please make sure the transformer is installed with adequate ventilation around it to allow for heat dissipation.
3)Ensure that wiring is correct before test in order to avoid light and power supply damage;
FAQ